|
The M75 Armored Infantry Vehicle is an American armored personnel carrier that was produced between December 1952 and February 1954, and saw service in the Korean War. It was replaced in U.S. service by the smaller, cheaper, amphibious M59. The M75s were given as military aid to Belgium, where they were used until the early 1980s. 1,729 M75s were built before production was halted. == Development == Towards the end of World War II, a tracked, fully enclosed armored personnel carrier was developed under the designation M44 (T16) that was based on the M18 tank destroyer. The M44 was extremely large (51,000 lb combat weight); carrying 24 infantry as well as a driver, bow gunner and vehicle commander. It was evaluated at Fort Knox and Aberdeen Proving Ground after the end of the war, but, ultimately, the army rejected the M44 as being too large - at the time, their tactical doctrine required infantry squads of ten men. As a result, only a handful of M44s were built, seeing service in a number of auxiliary roles. On 21 September 1945, a set of requirements were laid down for a squad sized armored personnel carrier, based on the chassis of the T43 cargo carrier. On 26 September 1946, the development of the T18 armored utility vehicle was approved with the International Harvester Corporation (IHC) contracted to produce four prototypes. The original mockup, which was designed to carry 14 people, including crew, featured two remote controlled .50 caliber machine guns, which could be aimed remotely by either the commander or either of the two gunners. The first prototype T18 dropped the assistant driver, but retained the remote controlled machine guns. The T18E1 pilot was unarmed and had a high cupola for the commander, this is sometimes referred to as pilot number 4. The T18E2 replaced the commander's cupola with a T122 machine gun mount, which could be fitted with either a .30 or .50 caliber machine gun. Though the original T18E1 prototype was unarmed, the high cupola was replaced with a variety of machine gun mounts before the M13 cupola, with a .50 caliber machine gun, was evaluated. The prototypes were originally powered by a six-cylinder Continental AO-895-2 air-cooled gasoline engine, which exhausted through the hull side grills. This was later replaced with the AO-895-4 in the T18E1,〔 which exhausted through a pipe mounted horizontally across the front of the vehicle. After acceptance testing, the T18E1 was ordered into production in 1952 as the M75. An order for 1,000 was placed with IHC and another, for 730, with the Food Machinery and Chemical Corporation. Numerous changes were made during the production run to reduce the cost and complexity. The number of shock absorbers was halved from four per side to two, and an auxiliary generator/heater was deleted. The two 75 gallon rubber fuel tanks were replaced by a single 150 gallon metal one. The M75 shared many chassis/suspension components with the M41 light tank, also powered by a Continental air-cooled engine. It had a cross-drive transmission (permitting pivoting, etc.), but was steered through two vertical handles, simulating the laterals of earlier vehicles controlled by track clutching/braking. The approximate cost of the vehicle was $72,000, which contributed to the early halting of production. The high profile (height) of the vehicle was also a negative factor. Additionally, the engine air cooling vents were considered to be vulnerable to small arms fire. However, the reliability of its drive system was far superior to that of its replacement, the M59. 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「M75 armored personnel carrier」の詳細全文を読む スポンサード リンク
|